To order the proper size and style, you’ll need a little belt information. You will need to know the WIDTH OF BELT, the STYLE of belt you’d like, the TYPE and SIZE of BUCKLE, and the SIZE of belt needed. Pictures are included to make this clearer, and you can always ask if you are unsure.
WIDTH of belt:
Belts are available in widths from 3/4″ to 2 1/2″ wide. Your belt must fit both the buckle and any loops it needs to go through. Beyond that the width is largely a cosmetic decision. 1 1/2″ wide is by far the most popular width requested.
STYLE of belt:
Your belt may be “straight cut”, tapered, or ranger style.
Straight cut belts are just that – the same width all around.
Belts with tapered ends – or “billets” – reduce bulk in the front of a belt, or to allow the use of a narrower buckle.
Ranger style belts, long popular for use as gun belts, are also popular western wear. We sew narrower “billets” to the main body of the belt, which allows the use of narrower buckles.
TYPE of buckle:
Buckles come in so many styles, sizes, and materials it’s unreasonable to try to list them all.
As a rule, I use three basic types of buckle: heel bar, center bar, and trophy. Ranger or “western” belts may use a 3-piece of 4-piece buckle set, but these are not actually a separate “type” of buckle.
The length of the buckle, becomes part of the total size measurement for the correct belt information. The picture at left shows how to measure the type of buckle you have.
This picture shows the same belt in each row. Note how the change in buckle causes a change in the size.
Changing the buckle for one an inch longer will change the size by that inch.
SIZE of belt:
The web offers much confusion about how to obtain the correct size for your custom belt. I could state some of it here, but the idea is to REDUCE confusion, not create it.
Please DO NOT order by the “size” on your jeans. Different clothing makers size differently. I have jeans that don’t fit, and jeans that would fall off without a belt – yet they both say the same size! Also, consider department store “vanity sizes”. We have all seen belts which, for example, are marked 38 but measure 42.
For the correct size, either measure around yourself at the point you will wear the belt (waist, hips, etc), or measure a belt that fits you the way you like it to.
If you are measuring your current belt, mark from the “cross” point of the buckle to the hole you currently use, as shown below. Then also let us know the thickness of your belt as thickness affects the size. If your old belt and the new belt are the same thickness, then they can be made the same size.
Though not a “type”, women often wear belts threaded “to the right”, opposite a ‘mans’. Perhaps this no longer applies. Let us say “buckle left” or “buckle right”. Worth noting, since ordering the belt to thread the other way will make any words or letters upside down when reversed.